Bulk add the same Observation on a Plan (Blast Mode)

The purpose of this article is to discover how to bulk pin the same observation to a plan using the Blast mode on the Mobile application.

  1. Open the desired project
  2. Click Plans
  3. Navigate and open the desired Plan
  4. Pinch-to-zoom (touch two fingers on the touch screen, and move them apart to zoom in, or together to zoom out) into the location you wish to raise the observation
  5. Make sure the observation icon is selected
  6. The Blast mode is represented by the circular icon located on the top right-hand corner


  7. Press that circular icon and drag & drop it on your desired first location
  8. Tap on the center of the circle and a hollow frame will be displayed


  9. Repeat the process until all locations have been defined


  10. Once finished, click the tick to validate the position
  11. If this is the first observation you are raising from your session, you will be prompt to select the Issuer and the Phase, then click Continue


  12. Enter all the required information (description, position, assignee, due date, photo, etc.)
  13. Click Save upon completion


All observations will be pinned to the plan and contain two important pieces of information:

  • Observation ID number
  • Status colour (in this example, Red is for Raised)



Once you finished your inspection and you have a stable internet connection, remember to synchronise your work so your data is available on the Web Application 


Need further help? Contact our Support Team